N10-009 ยท Media, transceivers and topologies
Copper cabling and Ethernet standards
Twisted pair categories, coax, DAC/twinax, plenum vs non-plenum, 802.3 standards and speeds.
Key points
- Cat5e 100 MHz, Cat6 250 MHz, Cat6a 500 MHz.
- Channel: 100 m (90 m permanent link plus patch cords).
- 10GBASE-T: Cat6a to 100 m, Cat6 only about 55 m.
- 1000BASE-T (speed, signaling, medium): 1 Gbps, baseband, twisted pair.
- Coax: F-type, BNC. DAC (twinax): short fixed copper rack cable, transceivers built into both ends.
- Plenum: low-smoke, fire-retardant jacket for air-handling spaces; no speed change.
Source: https://en.wikipedia.org/wiki/Category_6_cable
Practice questions
Which twisted-pair category is needed to run 10GBASE-T over the full 100 m channel?
- Cat5e
- Cat6
- Cat6a
- Cat3
Show answer
Answer: C. Cat6a
Cat6a (500 MHz) supports 10GBASE-T to 100 m. Cat6 only reaches about 55 m at 10 Gbps, and Cat5e is not intended for 10GBASE-T at all.
Which statements describe plenum-rated cable?
- Its jacket is low-smoke and fire-retardant
- It is meant for air-handling spaces such as return-air ceilings
- It carries data faster than non-plenum cable of the same category
- It is intended for direct burial outdoors
- It is completely immune to electromagnetic interference
Show answer
Answer: A. Its jacket is low-smoke and fire-retardant, B. It is meant for air-handling spaces such as return-air ceilings
Plenum jackets are low-smoke and fire-retardant and are meant for air-handling spaces such as return-air ceilings. The rating is about fire safety, not speed, outdoor burial or EMI immunity.
True or false: plenum-rated cable supports higher speeds than non-plenum cable of the same category.
Show answer
Answer: False
False. Plenum describes the jacket's fire and smoke behavior. Speed depends on the category (Cat5e, Cat6, Cat6a), not on the jacket type.
Practice 8 questions on this topic in Bitzu
Short lessons, instant explanations and spaced review of what you get wrong. Free on iOS and Android.
