N10-009 ยท Disaster recovery and network services
Disaster recovery metrics and tests
RPO, RTO, MTTR, MTBF, tabletop exercises and validation tests.
Key points
- RPO = how much data you can afford to lose, measured in time back from the failure.
- RTO = how long a service may stay down before recovery.
- MTTR = average time to repair a failed component.
- MTBF = average time a component runs between failures.
- Tabletop exercise = a talk-through of the plan with no systems touched; validation test = actually exercising the recovery (restore, failover) to prove it works.
Practice questions
Which metric defines the maximum acceptable amount of data loss, expressed as time?
- RTO
- RPO
- MTTR
- MTBF
Show answer
Answer: B. RPO
RPO (recovery point objective) is the age of the newest usable recovery point. RTO is about downtime, not data loss.
Which statements about DR metrics are correct?
- RTO is the target time to restore a service after an outage
- MTTR is the average time needed to repair a failed component
- MTBF is the average time taken to repair a failure
- RPO is the maximum acceptable downtime
- A lower RPO means a restore point closer to the moment of failure
Show answer
Answer: A. RTO is the target time to restore a service after an outage, B. MTTR is the average time needed to repair a failed component, E. A lower RPO means a restore point closer to the moment of failure
RTO is a downtime target and MTTR measures repair time; both are time-to-restore ideas. MTBF measures uptime between failures, and RPO concerns data loss, so those two statements are wrong.
True or false: a tabletop exercise proves the recovery procedures work because systems are failed over during the session.
Show answer
Answer: False
A tabletop is a discussion of the plan; no systems are touched. Proving that failover or restore actually works needs a validation test.
Practice 8 questions on this topic in Bitzu
Short lessons, instant explanations and spaced review of what you get wrong. Free on iOS and Android.
