JN0-106 ยท Interfaces and system services
Configuring interface properties
Setting family inet and inet6 addresses, description, MTU, speed and duplex, enable or disable, and verifying with show interfaces.
Key points
- Physical properties (description, mtu, speed, link-mode, disable): directly under the interface.
- Families and addresses: under a unit: set interfaces ge-0/0/1 unit 0 family inet address 192.0.2.1/24; family inet6 for IPv6.
- set interfaces ge-0/0/1 disable: shuts it without deleting its configuration.
- show interfaces terse: admin/link state, addresses.
- show interfaces ge-0/0/1 extensive: counters, errors.
Practice questions
Which operational command gives a one-line-per-interface summary of admin state, link state and addresses?
- show route terse
- show interfaces terse
- show interfaces extensive
- show chassis hardware
Show answer
Answer: B. show interfaces terse
show interfaces terse prints one compact line per logical interface. extensive is a long per-interface dump, and the other two are not about interfaces.
Which commands help you verify an interface after configuring it?
- show configuration interfaces ge-0/0/1
- show system uptime
- show chassis alarms
- show interfaces terse
- show interfaces ge-0/0/1 extensive
Show answer
Answer: A. show configuration interfaces ge-0/0/1, D. show interfaces terse, E. show interfaces ge-0/0/1 extensive
terse shows state and addresses, extensive shows counters and errors, and show configuration shows what was committed. Uptime and alarms do not describe the interface.
True or false: adding the disable statement to an interface deletes the rest of that interface's configuration.
Show answer
Answer: False
False. disable only shuts the interface administratively. The addresses and other settings remain in the configuration.
Practice 8 questions on this topic in Bitzu
Short lessons, instant explanations and spaced review of what you get wrong. Free on iOS and Android.
