Bitzu

N10-009 ยท Troubleshooting methodology, cabling and interfaces

Cable and signal problems

Wrong cable type, Cat 5/6/7/8, STP vs UTP, crosstalk, interference, attenuation, improper termination, TX/RX reversed.

Key points

  • Cat 5e: 1 Gbps. Cat 6 and 6a: 10 Gbps (6a over the full 100 m). Cat 7/8: higher speeds, shorter reach.
  • Single-mode vs multimode fiber must match the optics.
  • STP resists interference better than UTP.
  • Attenuation grows with length; crosstalk is bleed between pairs; EMI comes from motors and lights.
  • Bad terminations (too much untwist, split pairs, open pins) and reversed TX/RX kill links.

Practice questions

Single choice

Which copper category is the minimum that supports 10GBASE-T over the full 100 m channel?

  1. Cat 3
  2. Cat 5e
  3. Cat 6
  4. Cat 6a
Show answer

Answer: D. Cat 6a

Cat 6a is rated for 10 Gbps over 100 m. Cat 6 manages 10 Gbps only over a shorter distance, and Cat 5e and Cat 3 are too slow.

Select all that apply

Which conditions can degrade a copper signal?

  1. Crosstalk between adjacent pairs
  2. A run longer than the 100 m limit
  3. An exhausted DHCP scope
  4. Interference from nearby motors or fluorescent ballasts
  5. A wrong access VLAN on the port
Show answer

Answer: A. Crosstalk between adjacent pairs, B. A run longer than the 100 m limit, D. Interference from nearby motors or fluorescent ballasts

Crosstalk, attenuation from excess length and EMI all weaken or corrupt the signal. DHCP exhaustion and VLAN mistakes are higher-layer problems.

True or false

Plugging a Cat 6 cable into two 1 Gbps ports makes the link run at 10 Gbps.

Show answer

Answer: False

Link speed is limited by the slowest component. The cable's rating is a ceiling, not a speed boost.

Practice 8 questions on this topic in Bitzu

Short lessons, instant explanations and spaced review of what you get wrong. Free on iOS and Android.

Download on the App StoreGet it on Google Play

More N10-009 topics in this module