N10-009 ยท Troubleshooting methodology, cabling and interfaces
PoE budget, PoE standards and transceiver problems
PoE budget exceeded, wrong PoE standard, transceiver mismatch and signal strength.
Key points
- PoE: 802.3af up to 15.4 W per port, 802.3at (PoE+) up to 30 W, 802.3bt up to 60 W (Type 3) or 90 W (Type 4).
- PoE budget: the switch total; when devices demand more, ports lose power.
- Transceivers: both ends need the same type and wavelength, the right fiber mode (single-mode vs multimode), a clean connector, right transmit/receive polarity.
- Weak receive light level: dirt, a bend or too much loss.
Practice questions
Which standard provides up to 30 W per port at the power source (PoE+)?
- IEEE 802.3af
- IEEE 802.3at
- IEEE 802.3bt
- IEEE 802.3ab
Show answer
Answer: B. IEEE 802.3at
802.3at is PoE+ with up to 30 W at the source. 802.3af tops out at 15.4 W and 802.3bt reaches 60 to 90 W.
Which situations can cause a fiber link to stay down or run with errors?
- A multimode optic connected to single-mode fiber
- Different wavelengths at the two ends
- A receive light level too low because of a dirty connector
- A PoE class that is too low
- The wrong VLAN on the port
Show answer
Answer: A. A multimode optic connected to single-mode fiber, B. Different wavelengths at the two ends, C. A receive light level too low because of a dirty connector
A mode mismatch, a wavelength mismatch and a receive level too low from a dirty connector all break or degrade fiber links. PoE class and VLAN do not affect optical links.
An 802.3af port can power a 60 W 802.3bt device at its full rated power.
Show answer
Answer: False
A port can supply only up to its own standard's limit, 15.4 W for 802.3af. The device may stay off or run with reduced features.
Practice 8 questions on this topic in Bitzu
Short lessons, instant explanations and spaced review of what you get wrong. Free on iOS and Android.
