N10-009 ยท Troubleshooting methodology, cabling and interfaces
Reading interface counters and port status
CRC errors, runts, giants, drops; err-disabled, administratively down, suspended.
Key points
- CRC/FCS errors: frames damaged in transit (bad cable, interference, duplex mismatch).
- Runts: below the 64-byte minimum. Giants: above the maximum size.
- Drops: frames discarded, often from congestion.
- Down: no link. Administratively down: someone shut the port.
- Err-disabled: the switch shut it after a violation (port security, BPDU guard, flapping).
- Suspended: pulled out of a bundle or VLAN-related state.
Practice questions
What is a runt?
- A frame larger than the maximum allowed size
- A frame discarded because a queue was full
- A frame with a correct checksum but wrong VLAN
- A frame smaller than the 64-byte minimum
Show answer
Answer: D. A frame smaller than the 64-byte minimum
A runt is an Ethernet frame shorter than the 64-byte minimum, often from collisions or a faulty NIC. A giant is the opposite, too large.
Which events can put a switch port into the err-disabled state?
- A port security violation
- A BPDU received on a BPDU guard port
- An administrator typing shutdown
- Excessive link flapping detected by the switch
- The cable being unplugged
Show answer
Answer: A. A port security violation, B. A BPDU received on a BPDU guard port, D. Excessive link flapping detected by the switch
Port security violations, BPDU guard violations and link flapping detection can all err-disable a port. A manual shutdown gives administratively down, and an unplugged cable gives plain down.
A port shown as administratively down means the physical link has failed.
Show answer
Answer: False
Administratively down means someone shut the port with configuration. The link may be perfectly healthy; you must enable the port.
Practice 8 questions on this topic in Bitzu
Short lessons, instant explanations and spaced review of what you get wrong. Free on iOS and Android.
