N10-009 ยท Routing
FHRP, VIP and sub-interfaces
First hop redundancy protocols, virtual IPs, router-on-a-stick sub-interfaces.
Key points
- A first hop redundancy protocol (HSRP, VRRP) lets two routers share a virtual IP (VIP) that hosts use as the default gateway; the active/master router forwards, and the backup takes over if it fails, so hosts need no change.
- A sub-interface is a logical interface on one physical port; router-on-a-stick uses one per VLAN on a trunk to route between VLANs.
Practice questions
With HSRP or VRRP, which address do the hosts use as their default gateway?
- The virtual IP address of the group
- The physical IP of the active router
- The physical IP of the backup router
- The broadcast address
Show answer
Answer: A. The virtual IP address of the group
Hosts point at the shared virtual IP, which follows whichever router is currently active. A physical router address would break on failover.
Which statements about HSRP are true?
- The default priority is 100
- Preemption is off unless configured
- The active router forwards traffic sent to the virtual IP
- The virtual MAC starts with 00-00-5E-00-01
- Peers must form a BGP session
Show answer
Answer: A. The default priority is 100, B. Preemption is off unless configured, C. The active router forwards traffic sent to the virtual IP
HSRP defaults to priority 100, preemption must be enabled explicitly, and the active router forwards traffic for the virtual IP. The 00-00-5E-00-01 virtual MAC belongs to VRRP, and BGP is not involved.
True or false: after an FHRP failover, every host must be reconfigured with the new router's address.
Show answer
Answer: False
False. Hosts keep using the same virtual IP; the new active router answers for it.
Practice 8 questions on this topic in Bitzu
Short lessons, instant explanations and spaced review of what you get wrong. Free on iOS and Android.
