Bitzu

JN0-106 ยท Initial configuration and access control

Factory-default state and first-time setup

Factory-default configuration, root authentication, host name, management interface and the minimum steps for first-time setup, including load factory-default.

Key points

  • In configuration mode, load factory-default replaces the active configuration with the factory one and clears earlier committed settings.
  • Afterwards you set the root password (system root-authentication) and commit.
  • Typical first steps then: host-name, a management interface address, and the services you need for remote access, because remote access is off by default.

Source: https://www.juniper.net/documentation/us/en/software/junos/cli/topics/topic-map/junos-factory-default.html

Practice questions

Single choice

Which configuration-mode command replaces the active configuration with the factory-default one?

  1. rollback 0
  2. load factory-default
  3. commit factory-reset
  4. delete system root-authentication
Show answer

Answer: B. load factory-default

load factory-default does exactly this. rollback 0 only discards uncommitted edits, and request system zeroize is an operational-mode wipe, not a config load.

Select all that apply

Which tasks belong to a typical first-time setup of a Junos device?

  1. Set the root password with root-authentication
  2. Establish BGP sessions with all neighbors
  3. Set a host name
  4. Give the management interface an IP address
  5. Write a firewall filter for every interface
Show answer

Answer: A. Set the root password with root-authentication, C. Set a host name, D. Give the management interface an IP address

Root password, host name and a management address are the usual first steps. BGP peering and per-interface firewall filters are later, optional design work.

True or false

True or false: with the factory-default configuration, Telnet is already available for remote logins without any configuration.

Show answer

Answer: False

False. Remote access is disabled by default and each service must be enabled explicitly under system services.

Practice 8 questions on this topic in Bitzu

Short lessons, instant explanations and spaced review of what you get wrong. Free on iOS and Android.

Download on the App StoreGet it on Google Play

More JN0-106 topics in this module